![]() The I2C/TWI stuff uses 7 bit addresses (even if the address fits into 6!) and depending on a read or write action, shifts it up one bit and ORs in a 1 (for read) or a 0 (for write) to the lowest bit, bit 0, giving the two 8 bit addresses, one for reading and one for writing. ![]() It actually is a 6 bit address, while the following 0x7F is data. I am aware of the 7 bit address limits and so I believe the 0x37 I am sending is a valid address. Wire.begin() // join i2c bus (address optional for master) All suggestions are welcome and most likely it’s something that I am forgetting although all the sample code I’ve viewed does not show me anything I am missing. I’m working on a development board and my EE says that it looks like a software issue. I’ve tried everything I can think of including setting the clock rate but the second and third byte are no where to be seen. When I run the following code I only see one byte of transmission on an oscilloscope over and over (every 100 ms). I’m having trouble with the wire library. I’m working in Visual Studio Code with the Platform io extension on a Mega 2560. Wire.Hi, Last month my password word was stolen from my Arduino account and they have temporarily blocked me out so I thought to post my question here. Wire.endTransmission(true) //true=send stopĪrduino addresses are 7 bit (excluding RW bit), so I2C byte address 0x40 needs to be changed to 0x20 for arduino functions.Ĭlock Speed tClock(100000) //100000 = standard mode 0=success, 1=tx buff overrun, 2=NACK on address tx, 3=NACK on data tx, 4=other error If (Wire.endTransmission(false) = 0) //false=send restart (IMPORTANT-THIS ENDTRANSMISSION DOES NOT SEND STOP!). ![]() No need to send stop as done automatically Uint8_t BytesReceived = Wire.available() //The slave can send less than was requested ![]() Wire.requestFrom(0x5a, 2) //Address, no of bytes Result: 0=success, 1=tx buff overrun, 2=NACK on address tx, 3=NACK on data tx, 4=other error ![]() Uint8_t Result = Wire.endTransmission(true) //true=send stop Seems to be 7 bit value with bit0=lower bit (not I2C RW bit), so left shifted by 1 when sent over the wire. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |